Who We Serve
Electrical for manufacturing & industrial facilities
Commercial and industrial electrician in Richardson and North Dallas for equipment installation, motor controls, transformers and production-aware maintenance.
Manufacturing facilities treat their electrical system as production infrastructure, and downtime has a number attached to it. Work has to be specified correctly, installed to the manufacturer's documents, and scheduled around production, not the other way around.
Where a project needs a controls integrator, a startup technician, a millwright or a rigger, we coordinate with them directly. Our scope is the electrical installation and its supporting infrastructure, kept explicit so nothing falls between trades.
Equipment power to manufacturer specifications
Manufacturer equipment installation (MEI) starts with the cut sheet and nameplate: voltage, phase, full-load current, MCA/MOCP, disconnect requirements and control interfaces. We compare that to the building and surface mismatches before the machine ships, then install the feeder, raceway, disconnect and grounding it needs.
- Cut-sheet, nameplate and drawing review
- Voltage, phase and capacity verification
- Feeders, branch circuits and disconnects
- Coordination with vendors, millwrights and riggers
Motors, drives and controls
Three-phase motor work covers the branch circuit, feeder, starter, overload protection and control wiring. VFD installation follows the drive manufacturer's wiring methods. Proprietary programming stays with the manufacturer or controls specialist; we handle the electrical installation and support startup.
- Motor branch circuits, feeders and starters
- Overload relays, control transformers and pilot devices
- VFD installation, replacement and troubleshooting
- Interlocks, permissives and remote control wiring
Distribution, maintenance and downtime planning
We evaluate, repair, replace and expand switchgear, panels, transformers and feeders, and are straight about capacity when a new line needs more than the building has. Thermal imaging and planned de-energized maintenance find failures before the production schedule does, and every outage is planned around production.
- Three-phase panels, switchgear and feeders
- Transformer selection, replacement and maintenance
- Thermal imaging and preventive maintenance programs
- Expansion and capacity planning for new lines
Relevant services
Flip the Switch Electric serves Richardson, TX and the surrounding North Dallas area. Tell us what you're working on and we'll give you a straight answer on scope and fit.
Need an electrician who shows up and gets it right?
From a single service call to a full commercial project scope — tell us what's going on and we'll give you a straight answer on what it takes and when we can be there.